EGo3 Wave Instructions

EGO3 Wave commissioning

1. First, check if you ordered the correct filter. First try the filter without filter balls to see if it fits the connection.
2. Then open the container by pressing the 3 white dots and lifting the top part.
3. Now fill the container with 12 EGO3 filter balls.
4. Check the grid at the bottom to make sure it is seated correctly. The filter must never be used without this grid.
5. Next, the container is closed again. You will hear the clips snap. Then it is closed.
6. Place in the pool
   1. for types with thread, tighten by hand firmly
   2. for types with bayonet, turn straight, do not lean on it (see image 1 below)
7. and off you go

Ego3 filters have 40 times higher dirt absorption capacity than cartridges of the same size. So you only need to clean the Ego3 filter material very rarely. Thanks to our special silver fiber, the filter itself does not become a bacteria source.